Connection diagrams SDSystems mics
to Mipro-ACT707 miniXLRplugs
   
  You can connect the mic direct to the transmitter without use of our LP preamp  
 
1
LCM series condenser elements (LCM89 LCM85 LCM77 LCM70 etc)
  
   
  cutoff phonejack from our mic cable at the end
pictured above: backside of the 4-pin miniXLR to connect to the input of the transmitter:
solder audio (white inner lead) to pin 3 and + (red inner lead) to pin 4
split copper shield of mic-cable in 2 parts and solder to pin 1 and 2
 
     
2
LDM series Dynamic elements (LDM94/SDSmodular)
  
   
  cutoff XLR connector from our mic cable at the end
pictured above: backside of 4-pin miniXLR to connect to the input of the transmitter:
solder white inner lead to pin 3
solder shield of mic-cable together with Red inner lead to pin 1		  
     
3
FX/SX series condenser elements
  solder audio (white inner lead) to pin 2
solder pin 3 to pin 4 (without connecting it to a lead of the mic)
solder shield of mic-cable to pin 1
  
     
4 STM series condenser elements