. .LCM 110 HL for Violines
LCM 110 for Violine The LCM110 from SD Systems reaches the highest level in violin miking for classical as well as pop music. Due to the smoothly balanced frequency response and the omni-directional characteristics of the element, you get an optimal natural sound performance.
The holder fits in the hole of the tail-piece and works as a fine-tune mechanism, in order to get a shock mounted hang up. This will not hurt any part of the violin too! The thin and elegant goose-neck is easy to adjust, so that you can direct the mic to the part of the violin that you prefer for your personal sound. It comes standard with the "HL" line level mic pre-amp*.
Positioning:
Left: "strong" sound / Right: acoustic sound
flat frequency response
20-20.2000Hz.
thin goose-neck
very small and high-end capsule
shockfree mounted on tail piece
cannot hurt expensive violins!
 
HL preamp included
(with line-level output)
*available with XLR out preamp or with Blender
 
 
Specifications
. . .Frequency response
 
. . . . HL-Preamp included
PRO case included
 
 
   
Mic-type : condenser pressure microphone
Polar pattern omni directional
Frequency response: 20-20.000 Hz.
Sensitivity at 1 kHz : 10 mV/Pa +/- 2.5 dB
Output impedance at 1kHz 1.5 kohm
Signal to Noise ratio: 58 dB
Max Sound pressure level: 125 dB at 1% THD
Powering : 9V battery
Current-consumption : 150mA
Output: 6,3 mm jack plug on line-level
(for acoustic amp or mixer)
 
CLICK HERE for other types and accessories